Among the types of site that have appeared in recent years, one deserves to be described on its own: the sites related to energy storage and renewable power. They have transformers as well, and their insulating oil needs treatment as well, but what they ask of the equipment is not the same as in a conventional substation.
The difference in the conditions
A conventional substation is usually concentrated within one plant area, the oil runs from the transformer along a fixed pipework into the treatment unit, and that pipework is settled during the design stage. The sites of this kind are scattered, the quantity of oil at a single site is small, and the site is often a long way from the oil treatment equipment.
The direct consequence of that difference is this: when the oil has to be taken to a fixed unit for treatment, the transport, the temporary storage and the intermediate tank become parts of the process that have to be counted, and every extra transfer is one more chance for the oil to meet air and moisture. The oil itself is not cheap, and the losses and the secondary contamination on the way often deserve to be counted before the treatment cost does.

| Condition | Common in a conventional substation | Common in energy storage and renewable sites |
|---|---|---|
| Quantity and batches | Concentrated, large batches | Scattered, small quantity per batch |
| Position of the equipment | Fixed pipework, position settled at the design stage | Work is done on site, position limited by the conditions |
| Way of running | Arranged around the maintenance schedule | Arranged along the commissioning rhythm of the site |
| Supply and environment | Fixed distribution and an indoor environment | Outdoor installation and temporary supply both have to be considered |
What these conditions ask of the equipment
Small batches at scattered points ask for a machine that works as soon as it arrives: a mobile vacuum oil purifier such as the TYG-100 (6000 L/h) fits these sites better than a fixed unit, because the whole machine can be pushed to the door of the switch room or to the transformer and the number of transfer steps falls. The single-machine capacity does not have to be large, but the transport, the setting in place and the power supply should depend as little as possible on the conditions on site.
The other practical requirement is efficiency. When the quantity of oil is small, the warm-up and the vacuum pulling take up a larger share of the run, and how many batches the machine gets through in one night and how the intervals are arranged decide how much oil is dealt with. This is the side of the question that is easily missed when judging whether a machine fits: the parameter sheet carries a flow rate, not a batch rhythm.
- Confirm the power supply once the machine arrives: the ZYD and TYA series are built for three phase 380V / 50Hz, and the capacity and the phase of a temporary supply on site have to be checked first.
- Write the environmental conditions into the plan: the ambient temperature range of the equipment is -20~45 °C, and the difference between an outdoor site and a site in the highlands has to be taken into account.
- Altitude affects the vacuum level, so a high altitude site has to raise it at the stage of selection, not after the machine has been installed.
- The documents have to match each other: a site usually has its own document requirements, and the figures on the nameplate, in the manual and in the accompanying documents have to agree.
Conditions rather than a conclusion
A single fixed answer does not fit this kind of site. Where the oil is concentrated, a fixed unit with fixed pipework costs less; where the points are scattered and each batch is small, working on site with a mobile machine is usually the more workable way. What decides it is the number of transfer steps, the length of the maintenance window and the power supply on site, and those three come before the figures on the parameter sheet.
The same oil standard leads to a different way of working at different sites; the more scattered the points and the smaller the quantity, the fewer the transfer steps should be.
